Kramer Electronics VS-801USB Bedienungsanleitung PDF herunterladen (Seite 13)

10 VS-801USB - Operating the VS-801USB

5 Operating the VS-801USB

You can operate the VS-801USB via the front panel buttons (see Section 5.1), the

REMOTE contact closure terminal block connectors (see Section

5.2), the

application software (see Section

5.3) or the RC-IR3 IR remote control transmitter.

5.1 The Front Panel Buttons

To select a DEVICE to switch to the HOST, press one of the eight DEVICE

SELECT buttons.

5.2 The REMOTE Terminal Block Connector

The contact closure remote control pins operate in a similar way to the INPUT

SELECT button. Using the contact closure remote control (also known as push-to-

make momentary contact) you can select the desired USB port. To do so,

momentarily connect the required DEVICE pin (from 1 to 8) on the REMOTE

terminal block connector to the G (Ground) pin, as

Figure 5 illustrates.

Do not connect more than one PIN to the GND PIN at the same time.

Figure 5: Connecting the Contact Closure Remote Control PINs

5.3 The Application Software

Use the K-SINGLE control application software to control the VS-801USB via the

Ethernet or RS-232 9-pin D-sub.

The latest version of K-SINGLE and installation instructions can be

downloaded from the Kramer Web site at

www.kramerelectronics.com

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 23 24

Keine Kommentare

Kramer Electronics VS-801USB Bedienungsanleitung Seite 13