Kramer Electronics TP-575 Bedienungsanleitung PDF herunterladen (Seite 12)

KRAMER: SIMPLE CREATIVE TECHNOLOGY

Using the TP-575 HDMI Line Receiver / DA

5.3 Acquiring the EDID

Initially, the TP-575 operates with the factory default EDID

. This lets you

connect the power before connecting one of the acceptors or sources

You can acquire the EDID from:

• One output

• Two connected outputs, the Auto-mix Mode

(the relevant output illuminates)

• The Default EDID (both output LEDs blink)

(both output LEDs

illuminate)

To acquire the EDID, do the following:

1. Connect the power.

2. Connect the output or outputs from which you want to acquire the

EDID.

3. Press and hold the EDID SETUP button to select the desired EDID.

The OUT LEDs illuminate in the following cycle: OUT 1 (LINE),

OUT 2 (HDMI), both illuminate (Auto-mix

) and both blink (Default).

4. Release the button when reaching the desired set up

The EDID is now acquired.

1 The TP-575 reads the EDID, which is stored in the non-volatile memory

2 This is usually done only once, when the machine is being set up in an installation. Once acquired, the EDID is saved in

non-volatile memory and further acquisition is not necessary

3 The local output and the output on the receiver

4 The EDID acquired is a weighted average of all the connected outputs. For example, if several displays with different

resolutions are connected to the outputs, the acquired EDID supports all the resolutions, as well as other parameters included

in the EDID

5 If you set the machine to acquire the EDID from an output that is not connected, the Default EDID will be acquired

1 2 ... 7 8 9 10 11 12 13 14 15

Keine Kommentare

Kramer Electronics TP-575 Bedienungsanleitung Seite 12