Kramer-electronics PL-18 Bedienungsanleitung PDF herunterladen (Seite 12)

PL-18 Commands in Protocol 3000

Emit via serial port 1 four bytes – the binary representation of P2000 “all-in 2” serial command:

Using the binary port to send binary data:

#bin uart, 1, 4 <CR> “[" $01 $82 $80 $81 "]"

Emit via IR port 2 forty-two bytes – the binary representation of Kramer signal “button-1”:

#bin ir, 2, 42 <CR> “[" $FF $01 $8F $69 $67 $65 $66 $69 $66 $6C $63 $66 $C9 $68 $C8 $66 $CB $66 $C8

$CE $FF $01 $BC $69 $66 $66 $C8 $69 $66 $69 $66 $66 $66 $69 $66 $69 $65 $67 $65 $FF $EF $26 "]"

Using the binary port to receive and convey binary data:

Convey four binary bytes received on serial port 1 – these four binary bytes are the binary representation of the

P2000 “all-in 2” serial command:

#rbin uart, 1, 4 <CR> “[" $01 $82 $80 $81 "]"

8.2 12BHelp Commands

Command Syntax Response

Protocol handshaking

#CR ~OKCRLF

8.3 13BResult and Error Codes

Result/Error Syntax

Command ran successfully, no error.

COMMAND PARAMETERS OK

Protocol Errors:

Syntax error ERR001

Command not available for this device ERR002

Parameter is out of range ERR003

Unauthorized access (command run without the matching

ERR004

8.4 14BIdentification Commands

Command Syntax Response

Protocol handshaking

#CR ~OK CRLF

Read device model MODEL?

MODEL MACHINE_MODEL

Read device serial number SN?

SN SERIAL_NUMBER

Read device firmware

version

VERSION?

VERSION MAJOR .MINOR .BUILD .REVISION

Set machine name

NAME MACHINE_NAME NAME MACHINE_NAME RESULT

Read machine name NAME?

NAME MACHINE_NAME

Reset machine name to

factory default*

NAME-RST

NAME-RST MACHINE_FACTORY_NAME

RESULT

Visual identification IDV IDV OK

*Note: The machine name is not the same as the model name. The machine name is used to identify a specific

machine or a network in use (with DNS feature on).

MACHINE_NAME = Up to 14 alphameric chars.

* Machine factory name = Model name + last 4 digits from serial number.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 24 25

Kommentare zu diesen Handbüchern

Keine Kommentare

Kramer-electronics PL-18 Bedienungsanleitung Seite 12

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Schalttafel Kramer-electronics PL-18