Kramer-electronics PL-18 Bedienungsanleitung PDF herunterladen (Seite 8)

Connecting the PL-18 Control Port Expander

5 Connecting the PL-18 Control Port Expander

To connect the PL-18, as the example in Figure 2 illustrates, do the

following

1. Connect the RS-232 ports as follows:

 Connect RS-232/1 to a projector

 Connect RS-232/2 to a PC, touch screen or an RC device

2. Connect the RELAY

 Connect RELAYS 1 and 2 to window blinds

terminal block connectors as follows:

 Connect RELAYS 3 and 4 to a screen

3. Connect the IR OUTPUTS as follows:

 Connect IR OUTPUT 1 to a DVD

 Connect IR OUTPUT 2 to a display

Figure 2: Connecting the PL-18 Control Port Expander

1 Switch OFF the power on each device before connecting it to your PL-18. After connecting your PL-18, switch on its power

and then switch on the power on each device

2 On each 3-pole terminal block connector, connect either: C to NO, or C to NC (C is common, NO is normally open and NC

is normally closed)

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 24 25

Keine Kommentare

Kramer-electronics PL-18 Bedienungsanleitung Seite 8