Kramer-electronics SP-14 Bedienungsanleitung

SIERRA VIDEO SYSTEMS SP-14 Setup Guide

9 Set ARC Mode If you are converting the Aspect Ratio of the picture there are pre-set modes to choose from or a custom mode, if you choose Cus

10 Set MEMC Mode Background Motion Estimation Motion Compensated (MEMC) Frame Rate Conversion (FRC) creates temporally correct motion in a seq

11 Linear FRC can result in the appearance shown in the second picture where the moving parts of the picture result in adjacent frames being mer

12 FRC Level sets the amount of motion compensation difficulty tolerated before a frame is linearly converted. You may need to lower this level

13 Adjustment of MEMC Cadence and Mask Cadence Detection [MEMC/FRC Settings ] Time Code Settings Input Select

14 MEMC Mask (exclusion area) [MEMC/FRC Settings ] Time Code Settings Input Select 3G-SDI 1 Input

15 Input Settings SP-14 has many features to help improve and re-master older material. The default settings assume that your material is good

16 Input Capture allows you to over-scan the image and then move around inside the area, This is particularly useful when dealing with film tra

17 Input Select Buttons [Miscellaneous ] ↑ [Select Test Pattern SMPTE Color Bars ] Status Display Mode

18 Choice of Audio Source [Audio Input Select Mute] Input Pair 1 Mute N/A Input Pair 2 Mute

1 SP-14 Setup Guide Version 1.0

2 Contents Introduction 3 The Basic System 4 Flexible Connectivity 5 Control via Front Panel Button

3 Introduction This guide is a non-technical introduction to operating The SP-14 for up/down/cross standards conversion with MEMC

4 The Basic Setup The flowchart below represents the basic setup, additional information can be found further in this guide.

5 Flexible Connectivity The SP-14 can be used as a routing switcher and universal interface for connecting many up-to-date and legacy formats

6 Control via Front Panel LCD and Menu Buttons The SP-14 has front panel LCD display which gives status information and access to the in-built

7 Setting Scaler Functions Default Settings The SP-14 comes with default setting that should give good results on most content but you do need

8 Set Lock Mode In this same section of menu set the reference mode for the output of the SP-14. Using the up and down arrow keys move Output